SpokeFort™

BladeX TechnologyCarbon layup

SpokeFort™

Targeted Spoke Hole Reinforcement

Stronger spoke holes.
Less rim weight.
Built to protect the rim.

SpokeFort adds extra carbon specifically at each spoke hole. This localized layup strengthens the connection while reducing the material needed between holes.

See how it works
SpokeFort cutaway illustrating localized spoke hole reinforcement, with a 390 kgf pull-test label.

01 / ConstructionWhere the carbon goes

Reinforced at each
spoke hole.

Additional carbon layers are placed at individual spoke hole locations. The cutaway below shows the local buildup that reinforces the nipple seat.

Actual carbon rim cutaway, with localized carbon buildup visible along the lower spoke bed.
Visible in the lower section: the stacked carbon layers at the reinforced spoke bed. Photograph of the actual rim construction.

02 / StrengthAt the connection

Stronger
spoke holes.

The spoke nipple transfers spoke tension into the rim. Extra carbon around the hole reinforces this load-bearing area, increasing its resistance to nipple pull-through.

Local carbon buildup A stronger nipple seat

03 / WeightAcross the rim

Less material.
A lighter rim.

Reinforcement is concentrated at the holes. The same extra thickness does not need to continue between them, reducing overall rim weight compared with carrying that reinforcement around the spoke bed.

Targeted extra layers Less weight between holes

04 / EvidenceSpoke hole pull test

The nipple broke.
The spoke hole held.

390kgf

Minimum spoke hole pull-test result

Loaded until the nipple fractured.
Spoke hole: intact.

The minimum recorded load at nipple failure was 390 kgf. The spoke hole remained undamaged when the test ended.

Carbon rim mounted in a spoke hole pull-test rig, with a load cell, clamp and vertical spoke visible.
Spoke hole pull-test setup. Photograph retouched for presentation.
  1. LoadMinimum 390 kgf
  2. FailureSpoke nipple fractured
  3. RimSpoke hole remained intact

The test ended at nipple failure; the spoke hole’s ultimate failure load was not reached. The test load is not a recommended wheel-building spoke tension.

05 / Rim protectionWhy an intact hole matters

Protect the spoke hole.
Preserve the rim.

A broken nipple can be replaced. Damage to the rim’s spoke hole is a different repair problem. SpokeFort reinforces this critical connection to help protect the rim itself.

Replaceable componentSpoke nipple
Fractured in the pull test
Part of the carbon rimSpoke hole
Intact after the pull test

In the pull test, failure occurred in the nipple while the reinforced spoke hole remained intact. Preserving the hole can keep a wheel rebuild possible, provided the rest of the rim is also undamaged.

After an impact: an intact spoke hole alone does not establish that a rim is safe to reuse. Have the entire rim and wheel inspected by a qualified wheel builder before riding again.

SpokeFort™ / Targeted Spoke Hole Reinforcement